Mmaaikel's Smither BETA [Deleted]

Hi, I can't comment on your reply of my review, so I'll write it here.

When I said it sometimes gets stuck. I meant that while I was doing about 20 runs of iron nails it failed to put in an amount in the "Make X" menu twice, at about run n°5 and n°9.

Also, is smelting bars a viable option for this bot? Not a lot of good free bots that smelt are out there right now.

Kind regards.

 

I'd love it for the bot to work at Edgeville for all types of bar smelting :-D

Also, today I was making iron dart tips. The bot went to the bank, dropped off the dart tips it made but it couldn't find the iron bars in the bank to make more and stopped. Meanwhile there were still 270 iron bars. After a restart it was back to normal.

EDIT:
It did it again, basically it's trying to select "Withdraw All" but it sometimes hovers over "Withdraw 10" "Withdraw X" "Withdraw All" and "Withdraw 1" for a few seconds and finally it gives up. Saying that there are no more bars.
FYI: I'm running runescape on the standard client, with the expanded client view.

Let me know if you need any more info.

 

Aha I didn't know that, thanks! I don't think you need to length it, because the issue seems to be much less prominent when working in the standard view i.e. old runescape resolution.

Sounds good to me mate, I love your stuff

 

Amazing work! the only thing that would make it better is a break handler.

 

The bot is working flawless at varrock.

An anti-ban suggestion: add option for a random delay after finishing inventory

smithing is usually an afk skill and occasionally pausing for a little bit may be more realistic

 

I made 10,000 adamant dart tips (1,000 bars) in a little over 1 hour. I did not encounter any errors. If there was an option to make the bot stay at the anvil after creating. I would feel comfortable doing this to the 90s.
For example, Set the minimal number to 1 second and the maximum number to 20 seconds. Then it uses a random number between the two, to pick the time it sits at the anvil after smithing.

I am going to try to smith roughly 25k bars in the next week or so, I hope it all goes well xD

 

@Mmaaikel Funny thing is this still works even after the update where make all is an option. Would be nice to see a quick update to make this use make all instead of make X (not interface changed just an option change)

 

WOOOOOOOOOOOOO it uses make all now!

 

Is there a way to make it not move the screen if I have my screen open and it's positioned in a way where it can click on the anvil and bank(not the banker)?

Just have it click on random areas of the bank/anvil.